View Single Post
Old 10-04-2006, 12:44 PM   #14
ucbsti
Scooby Specialist
Member Sales Rating: (5)
 
Member#: 88105
Join Date: May 2005
Vehicle:
2005 STi
CGM, 2006 GG IX

Default

Not much really. You just have to screw the projectors to the bottom of the reflector housings. There are 2 screw holes on the bottom of the projectors and the bottom of them is flat. So 2 screws for each projector to solid mount them to the low beam reflector housing, maybe a little extra JB weld. Then you gotta seal up the back of the housing, but I have some large end caps from maxima headlights I will include, in addition to some other stuff and sealant

Then assemble and seal the lights again. The rest is wiring, I will include quick splice connectors on the bi-xenon solenoid harness so you can quick-splice into the high-beam wiring harness. Its just a simple 12v supply needed to operate the bi-xenon solenoid that flips down the cut off shield
* Registered users of the site do not see these ads.
ucbsti is offline   Reply With Quote