View Single Post
Old 02-25-2007, 08:09 PM   #1
shane04
Scooby Newbie
 
Member#: 129189
Join Date: Oct 2006
Chapter/Region: NWIC
Location: port orchard
Vehicle:
04 wagon
jbp surgeline tuned

Default not going into test mode when uploading a new map

i have a v1 ap put on a downpipe today, went to flash from stage 1 to stage 2 91 oct., the car went into test mode as it should,evrything seemed good,finished flashing and the car wouldnt start.after looking everything over, ensuring evrything had been disconnected properly i tried flashing the car to a stage 2 93 oct map, and noticed the car wouldnt go into test mode,tried flashing anyway and it still wouldnt start, so i reverted to stock, car started up i only ran it for a minute, shut the car off.i downloaded another stage 2 91 oct map from cobb and tried flashing it, this time the car went into test mode but once the flash was finished the car would not start.then i tried flashing to the stage 1 91 oct map that i had been running and the car would not go into test mode.then i got the "error please try operation again" message.looked it up in the manual and its the code for car not going into test mode,poor connection.tried resetting the ecu by disconnecting the battery,tapping breaks and letting it sit for an hour.then connected everything back up and tried to revert to stock,no test mode and the same error message.


this is on an 04 wrx with ap v1, any ideas?
* Registered users of the site do not see these ads.
shane04 is offline   Reply With Quote