View Single Post
Old 05-14-2007, 02:57 AM   #1
gthing
Scooby Newbie
 
Member#: 132190
Join Date: Nov 2006
Chapter/Region: RMIC
Location: Salt Lake City
Vehicle:
2003 WRX
Silver

Default Remote door lock/unlock

I have a unit that remote locks/unlocks my car. Currently it is spliced into the door lock/unlock wires located at the integrated module below the steering column.

Everything works okay, but it acts as if I am hitting lock/unlock on my door, not as if I have hitting lock/unlock on my OEM keychain remote. This means that although the door is unlocked, the factory alarm is still enabled.

My module currently sends a -12V pulse to lock/unlock the doors, but I can customize it to send a double pulse or any other type of pulse.

So my question is - where would I wire it up to mimick hitting lock/unlock on my keyless entry remote? This would disable the alarm and also trigger the lights to go on and off if I am correct.

Thanks.
* Registered users of the site do not see these ads.
gthing is offline   Reply With Quote