View Single Post
Old 08-21-2007, 12:25 AM   #4
B2.5GT
Scooby Newbie
 
Member#: 113120
Join Date: Apr 2006
Default

My drive shaft came out of my car that is about 62 inches or so and I need 63 and half inches or from one end to another end. RalliTek told me I need drive shaft from a Legacy that's from manual transmission. I'm trying to get one hear by Wesnday from Fastor Auto Parts but's so expensive 150 dollars. Hope it works. Another Question I had was if the pcm pin I need to ground was 81 or 82. Also I'm located in Portland Oregon. Thanks for the help everyone.....
* Registered users of the site do not see these ads.

Last edited by B2.5GT; 08-21-2007 at 09:46 AM.
B2.5GT is offline   Reply With Quote