Thread: Cosworth cams
View Single Post
Old 09-11-2007, 11:27 PM   #4
turbobaby
Scooby Newbie
 
Member#: 102564
Join Date: Dec 2005
Location: Toronto, Canada
Vehicle:
05 STi
BLUE

Default

Broken in properly, less than 10 psi, 4000 rpm limit. The other 3 cams were fine and the clearance was the same measurement as before. Only faulty cam clearance was drastically off. I am guessing the material the lobes were made out of were not hardened properly, but I not an engineer. Just can't believe cosworth/kelford would put out something like this
* Registered users of the site do not see these ads.
turbobaby is offline   Reply With Quote