View Single Post
Old 10-15-2007, 11:42 PM   #8
flycaster
Scooby Specialist
 
Member#: 60142
Join Date: Apr 2004
Location: Bend, OR
Vehicle:
2011 WRX
Grey

Default

Good deal. I know the theory is they pound in for a 100% seal after a very short time, but 8% seemed really high - especially the visible "mist" part.

There was a thread on another board where a guy could actually blow soap bubbles through a couple of valves right after a $1,500 head rebuild - turned out the factory replacement guides were incorrectly drilled and the hole was not concentric. The shop didn't pick up on this and needless to say the poor guy was upset, but in the shops defence it's probably not something that happens every day either. They fixed it with no whining.
* Registered users of the site do not see these ads.
flycaster is offline   Reply With Quote