View Single Post
Old 11-03-2007, 10:10 PM   #41
FuJi K
Scooby Guru
 
Member#: 3687
Join Date: Jan 2001
Chapter/Region: MWSOC
Location: St. Paul, MN
Vehicle:
MY99 GF4 JDM 6spd
NF Performance

Default

while a clutach install on my friends '95 Legacy, I got some 1mm plastic washers and stuck each at both sides of the joint. I cut the washer so it's not a "C" shaped instead of an "O" so I can slide it past the bolt. I was unable to pull off the WHOLE joint assembly because the tranny was still under the car and it's SUPER STUCK on there. BUT it was an AWESOME fit and now it feels AWESOME again. the slope sucked.
* Registered users of the site do not see these ads.
FuJi K is offline   Reply With Quote