View Single Post
Old 11-13-2007, 03:25 PM   #44
Legacy777
Scooby Guru
 
Member#: 4800
Join Date: Mar 2001
Chapter/Region: TXIC
Location: Houston, Tx
Vehicle:
1990 Legacy & 97 OBS
AWD 6MT EJ22T AWIC Swap

Default

As I mentioned in my original post, If you have a grinder, go make yourself a set of these.

Quote:
Slide the joint back on the shifter rod of the transmission, and reinstall the spring pins. This process can be a pain, because the spring pins do not want to stay put so you can knock them back into place. I ended up fabricating my own custom punches with 1/4" round bar & a grinding wheel. I made the tip of the round bar smaller so that it slid in the center of the spring pin to hold it on the bar. This provided enough support so that the spring pin didn't slide out when I was trying to reinstall it.

I would have been at it a lot longer if I hadn't of made these:
http://www.main.experiencetherave.co...m/DCP_4188.JPG
http://www.main.experiencetherave.co...m/DCP_4192.JPG
http://www.main.experiencetherave.co...m/DCP_4193.JPG
Josh
* Registered users of the site do not see these ads.
Legacy777 is offline   Reply With Quote