View Single Post
Old 05-27-2002, 12:08 PM   #5
8Complex

Moderator
 
Member#: 922
Join Date: Feb 2000
Chapter/Region: MWSOC
Location: Schaumburg, IL
Vehicle:
04 FXT
Red

Default

Quote:
Originally posted by IMPBOY
I'm not using the 98 rods. The stock 00 rod does not fit on the JE pistons because the wrist pin is too high. Basically the top of the rod does not clear the underside of the piston.
Can you shave some material off of the top of the underside of the piston to get it to work? Also, what about J&E? Did they tell you that you'd need new rods when ordering? IMO, they should make you a new set with a higher compression so that they still clear if they never said anything like that...
* Registered users of the site do not see these ads.
8Complex is offline   Reply With Quote