View Single Post
Old 12-28-2007, 04:17 PM   #1
Brock31
Scooby Specialist
 
Member#: 128115
Join Date: Oct 2006
Chapter/Region: South East
Location: Wilmington, NC
Vehicle:
2004 4EAT Wagon PSM
enginuity is cool

Default Inspections and "Not Ready" codes

Went to get my car inspected and when the OBDII computer was plugged in, the tech got a bunch of sensor not ready codes. I'm not exactly sure why. It has been a while since I last reflashed and and reset the ECU (disconnected neg. battery cable). I did change the oil last week, but the car has been driven several hundred miles since. Just before x-mas, I pulled a couple of logs and read the current map using Ecuflash. The car was parked for 4 or 5 days and then driven to get inspected today.
Would reading the map with Ecuflash cause the ECU to be put into a "not ready" state?

--Brock
* Registered users of the site do not see these ads.
Brock31 is offline   Reply With Quote