View Single Post
Old 01-17-2008, 07:54 PM   #14
Wrinkleboi
Top Scoob 006
 
Member#: 14424
Join Date: Jan 2002
Chapter/Region: South East
Location: Stuart, FL
Vehicle:
BugI w/ 07 STi Swap
www.TriStateTuners.com

Default

thanks for posting this, its awesome of you to share the work you've put in with everyone else. i am not familliar at all with excel at all so this is a little overwhelming for me.
i know there was short discussion about the new maf scaler integrated into enginuity and that it doesnt throw out the bad data but considering the ease of use is it something you'd recommend, or is it not developed far enough to be a reliable way to do maf scaling? if its not a reliable way to do it, maybe you should work with kascade to combine your forces and get it to where it needs to be
thanks again for helping out, definitely appreciated.
* Registered users of the site do not see these ads.
Wrinkleboi is offline   Reply With Quote