View Single Post
Old 06-15-2002, 01:49 PM   #2
tom@kartboy
NASIOC Vendor
 
Member#: 67
Join Date: Jul 1999
Chapter/Region: SCIC
Location: San Diego, CA
Vehicle:
1999 Outlasting
the competition.

Default

on the old kit i was using a -4 feed teed from the oil pressure sender(front of the block) and a -10 drain. never had any oiling problems. i dont think i would go any smaller than a -10.
also you need to make sure the drain is going down and not sideways or uphill.
hope this helps
tom@kartboy.com
* Registered users of the site do not see these ads.
tom@kartboy is offline   Reply With Quote