View Single Post
Old 03-02-2008, 11:58 PM   #9
wrxG
Scooby Newbie
 
Member#: 155087
Join Date: Jul 2007
Location: West Springfield MA
Vehicle:
04 WRX
PSM

Default

Quote:
Originally Posted by JoeT View Post
Here's a bunch of questions for you.

Is the EJ257 block new or used?
Have you matched "bored" the cylinders to match the pistons, or did you just drop in the pistons?
Did you check the piston to cylinder wall clearances?
Did you check clearances before assembling? (Plastigage the bearing mating areas when torqued down to spec)

Sorry for all the questions, just want to understand your build. Maybe more questions to follow depending on the answers.

Its a used EJ257
I ordered stock bore size pistons, i did not check for clearances though. I didn't think i would have to since the pisons should be the same size right?
* Registered users of the site do not see these ads.
wrxG is offline   Reply With Quote