View Single Post
Old 03-18-2008, 04:42 PM   #69
Eatoniashoprat
Scooby Newbie
 
Member#: 143416
Join Date: Mar 2007
Chapter/Region: W. Canada
Location: Saskatoon
Vehicle:
1971 Super Beetle
EJ20g Platinum Grey

Default

I used a pretty big gun and soldered the wires directly to the pins, it was a pain, but I personally wouldn't do it any other way. I just loaded a bit of solder on the wires, slid them underneath the pin on the coil pack, put some solder on the tip of the gun, then heated up the pin and the wire and pin fused together. I tugged and twisted the wires pretty good afterwards to make sure there were no cold solder joints.

Mike
* Registered users of the site do not see these ads.
Eatoniashoprat is offline   Reply With Quote