View Single Post
Old 03-18-2008, 08:41 PM   #68
shvrdavid
Scooby Specialist
 
Member#: 86078
Join Date: Apr 2005
Location: Central Pa.
Vehicle:
2005 Sti
4094R Twin Scroll

Default

Quote:
Originally Posted by tino View Post
Yeh thats a nice size but because of restrictions with RHD i could only maximally go 38mm IDA for the twin scroll upipe. So i figured that there was no point going bigger in the headers as it would get shoved back to the smaller diameter...
Hmm, I forgot it was right hand drive....
That would make for a lot more stuff to get around that is on the left side of my car...

I wish I new where a right hand drive car was around here that I could look at...
There has to be a way around it...

I am curious to see the difference the silicone coupler makes on your next dyno pulls...

Quote:
Originally Posted by tino
As for the cams my tuner said that if there were out it would be very obvious....
I am also curious how your tuner would know if a cam was off a few degrees without actually degreeing the engine with a degree wheel...

Nothing against your tuner, I would just like to know his trick in seeing an obvious 5 or 10 degree error in cam timing...
* Registered users of the site do not see these ads.
shvrdavid is offline   Reply With Quote