View Single Post
Old 03-23-2008, 11:26 PM   #5
Mechie3
Scooby Guru
 
Member#: 120152
Join Date: Jul 2006
Chapter/Region: MWSOC
Location: Indy
Default

Cut worm gear clamps can cut the hose as noted above
The worm gear clamps where the screw drive is pressed in (ie, not cut out) are a little better as they are smooth and won't cut tubes. Overtightening these can make the drive skip (loosen)
T-clamps are the best, overtightening these can cause the screw to break (I did it once) but mostly only on cheap clamps.
* Registered users of the site do not see these ads.
Mechie3 is offline   Reply With Quote