View Single Post
Old 03-29-2008, 03:20 PM   #1
SSLegacyGT
Scooby Specialist
 
Member#: 2865
Join Date: Nov 2000
Chapter/Region: NWIC
Location: CdA, ID
Vehicle:
2006 Legacy 2.5i
Wagon, 5MT, Blue

Default How do you remove aftermarket camber (eccentric) bolts?

So I got some camber bolts installed in the rear to allow me to correct my alignment after getting P1 springs. This was a few months ago, and now I need to take them out to put in my RCE coilovers. Seems easy enough right?

I don't know if I am missing something, but for some reason, I can not get the camber bolt out. I have rotated it in small increments while pounding on one side with a rubber mallet. It doesn't move more than 1/4" out, yet will still spin freely.

I'm sure it has to be lined up juuuust right to slip it through, but so far I have had no luck.

Any advice?

Thanks,

Derek
* Registered users of the site do not see these ads.
SSLegacyGT is offline   Reply With Quote