View Single Post
Old 04-03-2008, 01:36 AM   #32
99 rs
Scooby Specialist
Member#: 100994
Join Date: Nov 2005
Chapter/Region: W. Canada
Location: Edmonton
2005 Acura NSX-T
2007 Outback 2.5i


You have to unplug your RS fuel pump connector and plug the controller in between (no wiring involved). On the fuel pump controller (among the plug mentioned above) there are two wires running to the ECU. The wires for the controller are very long; I shortened mine up to not have extra wire. I made my own little harness and used all the plugs.

I also put some rubber to protect the wires from rubbing through (I later taped these wires together nicely).

I had these mirrors on my car for a while and they work great. They really are more of a novelty then anything but they look cool when you fold them in. Mine were originally silver so it was really hard to paint everything black and you could always see specs of silver behind the mirror. Plus the angles of the bases were designed for a RHD car. To get proper viewing angle you had to adjust them a stupid amount each way and they looked funny. So I thought I would just change the bases over. I was wrong. They did not fit in any way at all. A lot of “persuasion” was needed but they fit.

To get the mirrors off we used a heat gun on the lowest setting and constantly moved it around as to not create a hot spot.

* Registered users of the site do not see these ads.

Last edited by 99 rs; 04-29-2008 at 11:27 PM.
99 rs is offline   Reply With Quote