View Single Post
Old 04-03-2008, 02:53 AM   #43
99 rs
Scooby Specialist
 
Member#: 100994
Join Date: Nov 2005
Chapter/Region: W. Canada
Location: Edmonton
Vehicle:
2005 Acura NSX-T
2007 Outback 2.5i

Default

These are the wires that go behind the heater box. I ran all of my wires in the bulk harness to give it an OEM look. This is probably the main reason why I took the harness out. Note: this stage took my a while to do. The first time I put the AC box in the wires were really tight against the box. I wasn’t happy with the fitment. After un-taping some wires and re-taping them there is now about an inch give on the wires after everything is all bolted up. There is no sense in half-assing this stage after coming so far.


Motor ready to go back in. We drained the tranny fluid so it wouldn’t leak all over the place when the engine was up at an angle.










General picture with nothing hooked up.




* Registered users of the site do not see these ads.
99 rs is offline   Reply With Quote