View Single Post
Old 04-03-2008, 03:13 AM   #62
99 rs
Scooby Specialist
 
Member#: 100994
Join Date: Nov 2005
Chapter/Region: W. Canada
Location: Edmonton
Vehicle:
2005 Acura NSX-T
2007 Outback 2.5i

Default



Said cheap $7.99 paint


My heater controls also broke. Position 4 and 2 stopped working on the fan control. So I took these pictures for anyone wanting to know what the back side of their controls look like. Possibly to do a color change or something. Don’t mind the remote starter in the background, that’s for a different car altogether.






I finally cleaned up the battery cable wiring. If you look back a few pages you’ll notice the ground wire running across the battery. This is because the ground on the WRX is at a closer point. I extended the ground to the OEM RS location and still made the WRX ground for double action grounding.




I started on fitting the WRX rear seat. There is a lot more work then people think to make it look clean and proper. Most people I see just bolt down the rear seat and leave the exposed foamy side in the trunk. So essentially the lazy man way. There are many many holes that you can attach the to WRX carpet pieces to the car. I just used some of those carpet clips to hold the pieces in place. They seem do be doing the job. I’m going to finish this later though.


* Registered users of the site do not see these ads.

Last edited by 99 rs; 09-01-2008 at 04:01 PM.
99 rs is offline   Reply With Quote