View Single Post
Old 04-03-2008, 02:26 AM   #72
99 rs
Scooby Specialist
 
Member#: 100994
Join Date: Nov 2005
Chapter/Region: W. Canada
Location: Edmonton
Vehicle:
2005 Acura NSX-T
2007 Outback 2.5i

Default

T’d the boost line in






Finished product



Random picture




**************************************

Because a number of people ask how to take out the OBD2 plug from the lower dash piece this picture shows where to do it. The little slot of where the plug goes into has a tab holding the plug in. Stick a small flathead screw driver into that slot and the plug pops right out. You only need to do it on one side since the other will come out when you tilt the plug.



*********************************

Glove box light

If you note back a few pages during the wiring section I mentioned that I pre-wired in a glove box light. Now to finish off the install. This is just one of those small features that I love having. I always throw little papers in the glove box and now it’s so much easier to see them.

Here you can see the cut out of where the light is supposed to go. This is the original RS glove box and I have made no modifications to it. Like most things on the RS Subaru “half” put the light in.
* Registered users of the site do not see these ads.
99 rs is offline   Reply With Quote