View Single Post
Old 05-18-2008, 09:35 PM   #67
aboothman
Scooby Specialist
 
Member#: 127745
Join Date: Oct 2006
Chapter/Region: NWIC
Location: Humboldt County
Vehicle:
06 WRX 30r 6 speed
99L EJ255 6 Speed

Default

Quote:
Originally Posted by mikeis300 View Post
1st.
take the cluster out, then grab the B clip and plug in the 2 pins one in b22 and one in b20. run those down to the steering colum.

now take the bottom of you steering column apart. unscrew it then pull it away from the colum.
next look for the plug that goes into the headlight switch

now flip the plug over. and you should see where it says 17 on one cornner and 9 on the other. this are the marking the wires in the plug. so start at 9 and move over to the number 11 an 12.

clip them and leave room for a wire connector to go on them. then connect 12 to b22 and 11 to b20
Would you believe I actually did this when swapping my cluster? I thought it did not work though, since I had the headlight switch turned off when testing it

It is not a perfect solution, but it works. I too prefer to control the cluster than the console.

Once I get my 6 speed and Spiider DCCD, I will work on a way to wire the DCCD into the cluster. I do not think it will be too hard.
* Registered users of the site do not see these ads.
aboothman is offline   Reply With Quote