View Single Post
Old 05-28-2008, 02:14 PM   #1
douginportland
Scooby Newbie
 
Member#: 180950
Join Date: May 2008
Default newbie doesnt know which forum to look in for code resets

Hi and thanks for reading;

I bought a 97 Outback (autimatic transmission) in nice shape but test drove it in the day time and later after purchase while driving at night there were no instrument lights. Found that the fuse was missing altogether and replaced that. While under the dash I noticed unplugged green male /female clip wires. This was above the gas pedal more or less. I plugged it together and the check engine light started blinking. I used my auto Xray to pull the codes ( finally a reason to use it ! ) and got the speed sensor malfuntion code P0500 and and something else called a neutal position inhibiton switch circuit fault P1121 ? Also a P1540 vehicle speed sensor 2 range/ performance. Can I pull the ECU to reset ? Is it straightforward job to replace speed sensors ?

thanks again

D
* Registered users of the site do not see these ads.
douginportland is offline   Reply With Quote