NASIOC - View Single Post - Anyone have an old broken or otherwise coil they give me for cheap?

ciper · 07-17-2002, 04:51 PM

I want the connector from it, and the metal plate that surrounds it.

I plan try my own direct ignition design similar to that of the wrx.

I dont know if it will have any benefit, but its fun to try so? This will go along with the mrt equal length headers and cat (havnt decided on a muffler) then the afc and timing controller. Once all is installed Im going to spend the money to have someone help tune it the right way. Im still undecided but I wanted to do the parralel fuel rail mod and add a 3/4 inch spacer to the intake runners. Still havnt thought of a good material for it yet.

Anyone have an idea if epoxy would be possible?

* Registered users of the site do not see these ads.

07-17-2002, 04:51 PM	#5
ciper Scooby Guru Member#: 15543 Join Date: Feb 2002 Location: san francisco, ca Vehicle: 90BJ Legacy LS ABS AWD 946 Rio Red Jpn built	I want the connector from it, and the metal plate that surrounds it. I plan try my own direct ignition design similar to that of the wrx. I dont know if it will have any benefit, but its fun to try so? This will go along with the mrt equal length headers and cat (havnt decided on a muffler) then the afc and timing controller. Once all is installed Im going to spend the money to have someone help tune it the right way. Im still undecided but I wanted to do the parralel fuel rail mod and add a 3/4 inch spacer to the intake runners. Still havnt thought of a good material for it yet. Anyone have an idea if epoxy would be possible? * Registered users of the site do not see these ads. Last edited by ciper; 07-17-2002 at 04:58 PM.