View Single Post
Old 06-20-2008, 01:45 AM   #12
xxscaxx
Scooby Guru
 
Member#: 86459
Join Date: May 2005
Chapter/Region: Tri-State
Location: Campbell Hall, NY
Vehicle:
2013 BRZ
SWP

Default

so i checked my defi wires, and everything seemed to be ok. i accidently pulled some wires off when i pulled the clock up, but i fixed all the wires.

i think i was unclear about this, but when i connect the battery, the gauges do NOT sweep and turn on like normal. they just blink like they arent connected right. should i reconnect all the lines and make sure they are ok?

i just dont get it, i looked up tons of battery relocation tutorials on google, and they all are set up just like how i did mine. im pretty sure none of the wiring is incorrect.

also, can anyone tell me when you have the engine harness of, does the security light blink consistently? if it does, my problem might be with the defi wiring, not the re-wiring i did. i remembered that i had to switch my rca cable lines to the driver side (since i ran the pos. line for the batter on the passenger) so i might of pulled a wire loose or something.

someone help me out
* Registered users of the site do not see these ads.
xxscaxx is offline   Reply With Quote