View Single Post
Old 07-19-2002, 09:22 AM   #1
8Complex

Moderator
 
Member#: 922
Join Date: Feb 2000
Chapter/Region: MWSOC
Location: Schaumburg, IL
Vehicle:
04 FXT
Red

Default RC Injectors vs. stock intake manifold...

Ok, everyone that has RC Injectors please let me know how yours sit. I fitted mine to the intake manifold and found that I'll need larger o-rings (no biggie), but that also it sits down in there so far that the actualy body of the injector sits against the manifold.

Has anyone honed out the injector bores to make them fit better?

Has anyone filled in the air bleed channels to create an actual round bore instead of one interrupted by the air bleed hole?

Any problems with seating under boost? I heard a horror story about a set of Vishnu rails & RC injectors last night describing a loose enough fit with the o-ring that the injector was actually leaking air in & out of the manifold causing a cylinder to run lean/rich.
* Registered users of the site do not see these ads.
8Complex is offline   Reply With Quote