View Single Post
Old 06-23-2008, 02:49 PM   #262
frayz
Scooby Specialist
 
Member#: 106909
Join Date: Feb 2006
Location: Essex-England-United Kingdom
Vehicle:
2002 V7 STi Prodrive
Edition... Black!

Default

Well the ball is finally rolling...

I picked these little bits up tonight. I left the misc stuff such as the oil/water pumps etc etc at Zaks but here are my new internals ready to be checked cleaned measured and deburred.

I'll make a start next week probably, maybe this week if i get time.

Here we have brand spanking out of the wrapper a (new casting) EJ257 block that has been honed for my 99.5mm Wiseco forged pistons. These will be connected to a set of Carrillos finest A beam rods which in turn will be spinning on ACLs race series bearings.

This lot will be transfering their power to a brand new EJ257 STI crank (Should have arrived today but didnt... tut tut)

I'll leave you to enjoy a few crapy snaps if youre an engine pervert like me





* Registered users of the site do not see these ads.
frayz is offline   Reply With Quote