View Single Post
Old 07-18-2008, 06:16 PM   #1
skribblez32
Scooby Specialist
 
Member#: 120609
Join Date: Jul 2006
Chapter/Region: TXIC
Location: Austin, TX
Vehicle:
2006 2.5i
CGM

Default Gauge install question: Remote oil sender w/ t-fitting for pressure and temp?

Hey guys,

Been doing tons of research on gauges and gauge installs. However, I haven't read a post or thread on this topic.

I have decided on going with a remote oil pressure sender kit because of clearance issues and engine block vibrations on the sender unit of the electric gauges.
http://prosportgauges.com/remote-oil...ation-kit.aspx


1. My question is that, do I have to buy two of these? One for the oil temp and one for the oil pressure gauge? And also use the two gallery plug locations?

2. Can I just get one of these and get a t-fitting and hook up the two senders to one remote oil kit? If I can, I would probably go this route. Any tips on this would be awesome.


I decided against the sandwich oil adapters because of the possible leaks and hassle of changing seals, etc. However, the adapter would be a lot easier because most of them have two holes to plug in senders too...
I still might go with this route if the remote senders are a PITA.

Any help and suggestions are gratefully accepted. Thanks in advance!
* Registered users of the site do not see these ads.
skribblez32 is offline   Reply With Quote