View Single Post
Old 08-12-2008, 01:05 AM   #1
chargerbry
Scooby Newbie
 
Member#: 154007
Join Date: Jul 2007
Chapter/Region: NWIC
Location: Aloha Oregon
Vehicle:
2004 WRX Evo3 16g'D
07 6 speed

Default Weird tranny noise with new light flywheel and clutch??

I changed my factory flywheel out with an ACT pro light and then installed a centerforce dual friction clutch. The instant I drove it it felt great however it also instantly started to make tranny noise when I am compressioning down off the gas like either a bad bering noise or sycros just going crazy. As soon as I touch the gas it goes away. 2 days later the centerforce pressure plate exploded so I went to the Exedy stage 2 3 puck disk with matching pressure plate. It still makes the same noise. At first I thought is was the clutch but I now figure the flywheel does it cause it makes the same noise with both clutches. Anyone else have this noise after installing a light flywheel. I hope its only sycros whinning cause of the "less rotating mass" rather than maybe I found a bering problem when I lightened it up?

Any feedback would be appreciated
Bryan
* Registered users of the site do not see these ads.

Last edited by chargerbry; 08-12-2008 at 01:12 AM.
chargerbry is offline   Reply With Quote