View Single Post
Old 10-07-2008, 01:53 AM   #381
stan_tichomirov
Scooby Newbie
 
Member#: 150689
Join Date: Jun 2007
Location: Bay Area, California
Vehicle:
2007 Forester XT Ltd

Default

Car: 2007 Forester XT Limited 5MT
Facility: Fine Line Imports
Type of Dyno: Mustang
Baseline # for a stocker at the dyno: stock, my car made 188whp/211wtq on same dyno
Boost: 14psi tapering off to 11psi
Fuel: 91 octane Chevron California crap
Target AFR: not sure, can ask tuner
SAE Corrections: not sure
Peak HP at RPM: 255.0 @ 6,000 RPM
Peak Torque at RPM: 255.2 @3,500 RPM
Mods: VF43, STi TMIC, STi exhaust manifolds p&p by me, GREEN panel filter, COBB catted downpipe, Prodrive 2.5" axelback, COBB v2 AP tuned by FLI.

It did make 280 wtq on the COBB VF43 map, but was boosting a bit too high. This tune is conservative and safe, and the car pulls hard.

The "Base Run" plots are my car when it was stock:



This pull was done on a different day, over-layed with the previous graph:



This was a hot run with intake temperatures of 140 degrees, over-layed with the previous graphs (intake temperature 100 degrees). It is meant to show the difference in power after soaking up some heat -- the difference isn't too dramatic, which is great:



Stan
* Registered users of the site do not see these ads.

Last edited by stan_tichomirov; 10-07-2008 at 02:10 AM.
stan_tichomirov is offline   Reply With Quote