View Single Post
Old 11-04-2008, 10:37 AM   #19
SpankySuby
Scooby Newbie
 
Member#: 122305
Join Date: Aug 2006
Chapter/Region: SWIC
Location: Gilbert, Az
Vehicle:
2002 wrx half breed
Aspen White

Default

[quote=sorrowfulkiller;24328851]

I just wired the high beam power into them and then ground to battery ground and then used the parking light with a relay to power the normal headlight (just for saftey) and wired the turn signal to the parking light all of the bulbs i used were out of a nissan, the highs were a 350 Z then the fogs were out of a m45 and the headlight out of a altima



SpankySuby, I was curious how did you wire the high beams into the turn signal space? and what kind of bulb are you using? I was planning on modifying a 9005 bulb to fit but if you used something different I'd love to hear it, because it seams that unlike your setup mine would help greatly with high beams up there since there is such a good cutoff. The turn signals I'm not so worried about... I can just solder the stock ones over to that so... meh.
* Registered users of the site do not see these ads.
SpankySuby is offline   Reply With Quote