View Single Post
Old 11-06-2008, 03:41 PM   #161
Rene2.5RS
Scooby Specialist
 
Member#: 4574
Join Date: Mar 2001
Chapter/Region: NESIC
Location: Bristol, CT
Vehicle:
2011 Outback 2.5i L
VRP

Default

Quote:
Originally Posted by Geeoff View Post
I turned off my codes using opensource. Ive been going without the pump, valves, or lines for around 6 months, no problems at all.
I used open source to disable the CELs and after a year, no issues

Quote:
Originally Posted by jasonsp6 View Post
A painful, although easier method is to cut the hard line using a straight hacksaw blade. (just be careful you don't cut or knock off the turbo oil drain line). I used a 18tpi blade and it took about 5-10 minutes to get through it.
Yeah there is always going to be different ways to go about it. When I had the up pipe off to unbolt the hard line on the passenger side and install the block off plate to separate the inlet from the turbo and lift the line out was no biggie at that point.

-Rene
* Registered users of the site do not see these ads.
Rene2.5RS is offline   Reply With Quote