View Single Post
Old 11-11-2008, 06:24 PM   #8
FourOnTheFloor65
Scooby Specialist
 
Member#: 106225
Join Date: Jan 2006
Chapter/Region: MAIC
Location: Fairmont WV
Vehicle:
02 WRX STied PSM
03 L, 05 GT Legacy Wagons

Default

Quote:
Originally Posted by breezeby View Post
Yeah I wish someone would just test it after the cat and before the cat. But I guess I am just getting the o2 bung welded on the DP
Make sure to mount it at least a 8-10 inches behind the turbo. Wideband sensors read off and can be damaged when they get really hot. Inovate recommends, with their kits, if you have to place the sensor close to the turbo that you either buy there heatsink bung which is about $90 or make a heatsink out of copper sheet metal to go on the sensor. Overheated sensor are not just a problem with their kits it is a universal issue. You can go to Inovate's website and find the instruction manual for any of their kits. They all have a section about this heat sink.
* Registered users of the site do not see these ads.
FourOnTheFloor65 is offline   Reply With Quote