View Single Post
Old 11-12-2008, 04:19 PM   #53
ciper
Scooby Guru
 
Member#: 15543
Join Date: Feb 2002
Location: san francisco, ca
Vehicle:
90BJ Legacy LS ABS
AWD 946 Rio Red Jpn built

Default

Quote:
Originally Posted by Jaxx View Post
transmission mount is definitely something to look at i ripped apart 2 on my 94 ls (fwd)
I recently got a 4.44 final 4eat from the junk yard and it had a unique (to me) transmission mount design.

The mount was essentially normal except a stud extended from the upper plate (that touches the trans) and through a large hole in the lower plate (that touches the cross beam). The end of the stud had a large flat face with a bushing on it. Under normal conditions it made no contact with the lower plate but under extreme torque it would limit the distance the transmission would move!
Perhaps you could use something similar?
* Registered users of the site do not see these ads.
ciper is offline   Reply With Quote