View Single Post
Old 11-20-2008, 01:52 PM   #87
Asinine
Sufficiently Snarky
 
Member#: 55173
Join Date: Feb 2004
Chapter/Region: MAIC
Location: I beat up big rocks
Vehicle:
with paddles.

Default

After doing some research on the OEM specs and tolerances, it appears that the specs are given in degrees/minutes, but a lot of people are treating the minutes as "tenths." (e.g., Treating 130' the same as 1.3). Am I missing something, but isn't 130' actually 1.5?

Anyway, I'm seeing the tolerance for rear toe-in, each toe angle: 0.09' (0.15). Would this make the total toe tolerance 0.30? IIRC, the printout for the rear showed only the total rear toe, which was 0.19.
* Registered users of the site do not see these ads.
Asinine is offline   Reply With Quote