View Single Post
Old 12-01-2008, 05:56 PM   #10
VIsubi
Scooby Specialist
 
Member#: 187834
Join Date: Aug 2008
Vehicle:
06 2.5i impreza
Red

Default

most say they will but kinda wierd as to how that is....I think low compression psitons and forged rods will yield you good boost gains...just alot of work just to boost really..where as you'll spend the same amount for a swap...but if your going to be participating in the build you might enjoy it also..really its up too you but from what you've listed as a basic swap or boost build that sounds about right..440 injectors will work just fine no need for say 880's or so....most up pipes are attached to the headers so just get headers with it welded..avoid anthing bolted into headers...down pipe is fine cause it as a flange...
* Registered users of the site do not see these ads.
VIsubi is offline   Reply With Quote