View Single Post
Old 12-06-2008, 12:18 PM   #15
recnelis
Scooby Specialist
 
Member#: 92778
Join Date: Aug 2005
Chapter/Region: NESIC
Location: Connecticut
Vehicle:
2000 Impreza 2.5RS
#74 ST - RCE Tarmac 2

Default

Quote:
Originally Posted by Aspenbullet View Post
I can't seem to find the alignment specs but AFAIK it's set to factory specs since it was taken to the dealership.

Do Subaru factory alignment specs on a 2002 WRX call for the toe to be set to 0 on all tires?
The alignment specs should be in your factory manual. They are for my RS.

If you want to double check the work the dealership did, you could always try out the alignment thread in the suspension forum. With strings running parallel to the car, you can get a pretty good measurement of toe. If it's off, you can go yell at your dealership or fix it yourself. If it's good, then it might be something else.

My dad's RS had a similar looking wear pattern on his tires. When we finally checked it with the strings, we found about 3-4 mm of toe out on the worst wheel. The factory specs are supposedly +/- 3 mm (which is why being "in the green" or "factory spec" is not necessarily zero).
* Registered users of the site do not see these ads.
recnelis is offline   Reply With Quote