View Single Post
Old 01-03-2009, 10:12 PM   #60
Storm
Scooby Guru
 
Member#: 5218
Join Date: Mar 2001
Chapter/Region: MWSOC
Location: SAUL'S Motorsports
Vehicle:
96L Most Over-
Developed Beater

Default

Quote:
Originally Posted by ciper View Post
I recently got a 4.44 final 4eat from the junk yard and it had a unique (to me) transmission mount design.

The mount was essentially normal except a stud extended from the upper plate (that touches the trans) and through a large hole in the lower plate (that touches the cross beam). The end of the stud had a large flat face with a bushing on it. Under normal conditions it made no contact with the lower plate but under extreme torque it would limit the distance the transmission would move!
Perhaps you could use something similar?
My 96 Brighton had the same type of mount. Trim the top ears off an STI tranny mount and it'll sit down in the crossmember.

Jay Storm
* Registered users of the site do not see these ads.
Storm is offline   Reply With Quote