View Single Post
Old 03-13-2009, 12:04 AM   #27
OUScooby
Scooby Specialist
 
Member#: 100449
Join Date: Nov 2005
Chapter/Region: SCIC
Location: NoHo
Vehicle:
'04 WRX 307whp278tq
'99 Imp L, '72 MGB

Default

Quote:
Originally Posted by ADAS1223 View Post
If you could post dimensions, and meticulously explain the points for the holes (distance from each other/edges) please <taco rey wtf?
OK here is the measurement between the hole on the splash guard.
NOTE, it may not seem so because of the slight angle the photo was taken at, and because the splash guards is not laying perfectly flat, but all lines drawn intersect at right angles. The hole I plan to use for my skid plate are the ones circled in yellow.



Next step: make a final template with bends, make sure hole for oil filter and drain plug leave enough work room, and price out sheet metal.

Stay tuned.

Comments, criticism, and suggestions highly encouraged.
* Registered users of the site do not see these ads.
OUScooby is online now   Reply With Quote