View Single Post
Old 03-13-2009, 10:28 PM   #41
frederik
Scooby Specialist
 
Member#: 64405
Join Date: Jun 2004
Chapter/Region: E. Canada
Location: St-Georges, QC, Canada
Vehicle:
2003 WRX Sedan
WRB - Cobb Stg 2

Default

Quote:
Originally Posted by kh15 View Post
im getting this noise to with my newly installed stage 1 exedy clutch and oem flywheel.
is that normal for a oem flywheel?
I also have this kind of noise since today, but I have a stock flywheel on a 2003 WRX. I replaced the worn original clutch with a exedy oem replacement about 2 years ago.

Sounds like something loose inside the tranny when not under power or very slightly compressing. When decelerating in 3rd or 4th to a stop, when going below 2k there is a fairly loud low pitched vibration noise similar to a shot wheel bearing, but only for a few hundred rpm range.

It started after a ride in a dirt road, with a few hard starts in dirt. There may have been some ice spots while I was doing that but not sure, I did it where it appeared to be moslty dirt.

I will search on how to drain tranny fluid and see what I find in there.
* Registered users of the site do not see these ads.
frederik is offline   Reply With Quote