View Single Post
Old 04-19-2009, 12:18 PM   #54
gabedude
Scooby Guru
 
Member#: 10108
Join Date: Sep 2001
Chapter/Region: TXIC
Location: Lake Travis, Austin, TX
Vehicle:
07 STI
60Trim spun rod bearing

Default

I'm not sure, I'd have to look at my initial design again first and follow the lines. IMHO, the length of the line does not matter as it is all pressurized. Basically all I did was swap the return and feed on one side and T the inputs/outputs (before the stock rails where they attach) so I could keep the stock bottom hard lines (I don't want anything to kink and blow a piston). You could do this with the mani on as well.

I just needed one adapter though and the fuel line fits right on the stock FPR fat end like on the scoobymods tutorial. I ended up using less than 2 feet of goodyear fuel injection hose.

Gabe

EDIT: The length of the line after the Ts does matter, see my posts below
* Registered users of the site do not see these ads.

Last edited by gabedude; 06-14-2009 at 10:39 AM. Reason: Good idea at first but in practice it causes some issues
gabedude is offline   Reply With Quote