View Single Post
Old 05-05-2009, 08:08 AM   #25
Tea cups
Scooby Specialist
 
Member#: 103136
Join Date: Dec 2005
Default

Quote:
Originally Posted by RaceFaceXC View Post
There is no code to cancel the CEL forever... RomRaider allows the user to disable almost any of the CEL's from illuminating the dash light, however the CEL still occurs in the ECU, so if its something critical to engine function, it will make the necessary changes, like going into limp mode.
That is only true in the case of the 16-bit ECU, which does not apply to any N/A car tuneable in RomRaider (all use the 32-bit ECU). You disable the CEL in your car, it is disabled completely as far as the ECU is concerned. The only issue is that if it is relative to some sensor input, for example, and that input is now off or out of range because the sensor was removed, the ECU may react to that input as if the data was accurate, which may have some response. The typical scenario with Subaru is the removal of the rear o2 which will cause you to run richer in closed loop.
* Registered users of the site do not see these ads.
Tea cups is offline   Reply With Quote