View Single Post
Old 06-03-2009, 03:17 PM   #2
FkVtech
Scooby Specialist
 
Member#: 198968
Join Date: Jan 2009
Chapter/Region: Tri-State
Location: A pineapple under the sea
Vehicle:
2008 WRX
RIP Soccerkid52688

Default

1. Open trunk and remove inside panel from top
2. There will be 4 screws(Two on either sides, and two through two holes you have to get through)
3. Once screws are removed, push up on the piece starting on the outside moving in.
4. You may need to disconect the windsheild washer fluid line, it pops off and just tie it in a knot so fluid dosent go everywhere.
5. To remove the piece from the light, you need to slide the 3rd brake light out.
Hope that helped
* Registered users of the site do not see these ads.
FkVtech is offline   Reply With Quote