View Single Post
Old 03-01-2001, 08:31 PM   #17
joostin420
Scooby Specialist
 
Member#: 1046
Join Date: Mar 2000
Location: New England, United States
Vehicle:
2007 WRX Wagon
UGM

Thumbs up

check back at the top for the draft i made and, the machine shop went by it without a problem at all.

total cost was $100, and well worth it because it incorporates the shifter boot seat so the boot does not fall down and it is short in height, especially with the 2" tall knob.

oh, and all that needs to be done after being made is that the ball has to be filed down a TINY bit on the sides like the stock ball. i did this on 4 sides instead because the ball is 1/32" to 1/64" larger in diameter than the stock ball, which is very minute difference but makes the world of a difference when trying to insert the ball into the socket..

justin

[This message has been edited by joostin420 (edited March 02, 2001).]
* Registered users of the site do not see these ads.
joostin420 is offline   Reply With Quote