View Single Post
Old 10-14-2002, 12:27 AM   #7
8Complex

Moderator
 
Member#: 922
Join Date: Feb 2000
Chapter/Region: MWSOC
Location: Schaumburg, IL
Vehicle:
04 FXT
Red

Default MoTeC M4

MoTeC M4
www.motec.com

  • Is there a Subaru user base available for this ECU? If so, where?
    No.

  • An estimate of the ECU's pricing?
    $1600-2000

  • Is the ECU programmable by laptop, handheld controller, or both?
    Laptop only.

  • Does the ECU function in a "stand-alone" or "piggyback" fashion?
    Stand-alone.

  • Is the ECU delivered as a "kit", or a "plug and play" package? For what models?
    No, kits/packages are not available for any model.

  • What datalogging capabilities does the ECU have?
    Onboard logging only.

  • Does the ECU have the ability to control boost pressure?
    Yes. Main Table (3D) 20 RPM sites x 10 Throttle sites or 10 Gear sites.

  • Does the ECU allow for maps to be switched on the fly, and will it need to be "reset" before the map will take effect?
    Unknown.

  • Does the ECU have any sort of knock correction feedback?
    Changes can be made to the map itself on the fly. Does not need to be reset.

  • What type of correction factors (coolant temp, air temp, etc) does the ECU use?
    Intake Air temp., Coolant temp.

  • What oxygen sensors does the ECU unit utilize?
    Narrow-band or wide-band (optional).

  • Will the ECU drive low or high impedance injectors? Both impedance types?
    Both.

  • Will the ECU drive an additional 4 injectors (8 injector staged setup)?
    Yes.

  • What load references can the ECU use for tuning purposes?
    MAP, MAF, or TPS.

  • What resolution does the ECU offer in tuning (how many load points, RPM points, and what increments of adjustment)?
    Fuel:
    Main Table (3D) 40 RPM sites x 21 Load sites (840 points)
    End of Injection (3D) 20 RPM sites x 11 Load sites
    Individual Cylinder Tables (3D) 20 RPM sites x 11 Load sites
    Hi/Lo Injector Balance (3D) 20 RPM sites x 11 Load sites
    Hi/Lo End of Injection (3D) 20 RPM sites x 11 Load sites
    Ignition:
    Individual Cylinder Tables (3D) 20 RPM sites x 11 Load sites
    Rotary Split 20 RPM x 11 Load sites
    Dwell Time 20 RPM x 11 Battery sites


  • Does the ECU have the ability to drive external hardware? If so, how many, and what type?
    Yes, 2 additional configurable outputs.

  • Will the ECU run off of the stock crank position sensor? Or will one need to be fabricated?
    Yes, will run off the stock setup.
* Registered users of the site do not see these ads.

Last edited by 8Complex; 11-16-2002 at 03:15 PM.
8Complex is offline