View Single Post
Old 08-24-2009, 09:31 AM   #2
Matt A
NASIOC Vendor Manager

 
Member#: 15382
Join Date: Feb 2002
Chapter/Region: NESIC
Location: Cambridge, MA
Vehicle:
. 2005 OBXT LTD

Default

View of the Vandercook Press. You can see where the paper is fed into the press along the guides.




A stack of one run of many, many to come...




Now that the first run with the yellow is done, its time to clean the ink off the press and line up the next plate to run.




Run it a few times without ink to get the alignment correct and to do the major adjustments...




Ink the press up and run a few to get the minute adjustments and alignment just right...looking good!




The face uses a decent amount of ink and the paper is thirsty, so to keep the color consistent, I needed to add ink a few times during the run...




Grabbing the paper after I roll it over the plate




Check each one after it comes off the press. This one looks good! I also look damn fine in an apron if I do say so myself.




More ink...




Little guy all inked up

* Registered users of the site do not see these ads.
Matt A is offline   Reply With Quote