View Single Post
Old 11-18-2009, 12:28 AM   #1
STI_KLR
Scooby Specialist
 
Member#: 189660
Join Date: Sep 2008
Chapter/Region: MAIC
Location: Silver Spring, MD
Vehicle:
'02 WRX
Element Tuning Race Team

Subaru Stars STI_KLR's Built 2.5L Hybrid

How she sits right now:








Ok, here's a quick run down to catch people up:

February 7th: Cracked a ringland in the EJ20 in cyl #4
Feb-May: Slowly build up the 2.5L Hybrid (myself) with a brand new EJ257
End of May: Motor cranks up first try; 1,xxx mile break-in begins
June: Blow 2nd gear in the 5-speed
July: Replace 5-speed with JDM 6-speed
September: Break the bell-housing on the 6-speed
November: 2 cracked pistons lead to rapid oil consumption to spin rod bearings in cyl #2

# of times WRX has been towed since February: 8 and counting.


PRESENT DAY:

The WRX is currently at IAG Performance in Westminster, MD where all of the work is being done. The rod and crank were completely toast, so here is the work that has already been done. The BOLD parts are brand new, the rest are parts I already had.


EJ257 Shortblock
EJ20 Heads
OEM STI Headgaskets
ARP studs
08/09 STI Nitride Crank
SKAT Rods (1st motor IAG is using these rods in)
Manley 99.5mm Pistons
ACL Race Main/Rod Bearings
11mm Oil Pump
Custom IAG Oil Catch Can
STI Cams
Shimless Buckets
Gates Racing Timing Belt
New Oil Cooler
New WRX Oil Pan
DW 850cc Injectors
FP 20g 8cm^2 Turbo
Invidia Catless V2 Downpipe
P&L HighFLO Intake
IAG Oil Catch Can
TGV Deletes
TiAL 38mm EWG
Exhaust Mani/UP/DP/Dump Tube all thermal coated and DEI heat wrapped
Hallman Pro-RX MBC
NGK 1-Step Colder Plugs
Grimmspeed Thermostat
Grimmspeed 3mm Phenolic Spacers
Grimmspeed 3-Port BCS
Walboro 255 Fuel Pump
APS Turbo Inlet
CXRacing Aluminum Radiator
Group-N Motor Mounts
Group-N Tranny Mount



I know I'm forgetting some things right now, but it's late, i'm tired, so i'll update this tomorrow


-Andrew
* Registered users of the site do not see these ads.

Last edited by STI_KLR; 12-13-2009 at 12:40 PM.
STI_KLR is offline   Reply With Quote