Thread: 200 Whp
View Single Post
Old 12-13-2009, 02:56 AM   #17
CKxx
Scooby Specialist
 
Member#: 33458
Join Date: Feb 2003
Chapter/Region: Tri-State
Location: PA
Vehicle:
Your BOV sounds lame
93 RX7+09 Forester

Default

Quote:
Originally Posted by 801_STi View Post
k well..

1. at home on a nice even surface such as a table calibrate it in the settings menu.

2. set up your car, weight, etc

3. put somewhere in your car FLAT and facing directly forward ( i use center console ) place it on one of those pads that are for putting cell phones on your dash so it doesnt move at all

4. from a stand still press start when it says go it is ready and will start whenever you go

you do have to start from a stand still every time so it can tell when you start moving. every run is recording 1/4 of a mile, you may stop before a quarter mile if you would like and it will still give you the results.

what i have found is that if its calibrated very well that it will be about + or - .3 on the times section.. and horsepower i couldnt really tell you. all depends on how much drivetrain loss you have configured in and different dynos read different etc etc etc.
Cool. Thanks.

I'm not too worried about 1/4 times. I want to be able to compare as I turn up the boost.
* Registered users of the site do not see these ads.
CKxx is offline   Reply With Quote