View Single Post
Old 12-19-2009, 10:57 AM   #35
scrappydoo
Scooby Specialist
 
Member#: 23630
Join Date: Aug 2002
Chapter/Region: NWIC
Vehicle:
97 v4 STi RA
Feather White, 02 WRX MBP

Default

Quote:
Originally Posted by dr3w View Post
^ aw perfect your rhd as well. I was scared that the cold side pipe would hit the master booster but from your photos it doesn't! great
Ya, everything fit very well once I cut the pipes. You have to make the cuts anyway, so if you think you need to trim some off to avoid stuff it's no big deal. Btw, you'll really want to have the ends bead rolled. I had the pipes pop off a few times before I finally had it done.

Quote:
Originally Posted by corzy666 View Post
Which two pipes did you cut? The hot side by the bottom of the fender, and the hotside right after the turbo? I will be doing this install by Christmas and just want to make sure I have enough couplers. Thx
I cut mine once on the top pipe on the hot side and once before the throttlebody. You can see the one on the tb in my previous pic. Here's one of the hotside before I put the pipe on:
* Registered users of the site do not see these ads.
scrappydoo is offline   Reply With Quote