View Single Post
Old 01-13-2010, 04:27 PM   #4
cooleys04
Scooby Specialist
 
Member#: 145027
Join Date: Apr 2007
Chapter/Region: SWIC
Location: phoenix
Vehicle:
2004 WRX FP Green
MFactory/2Tone/built 205

Default

I ran a jumper wire from the battery to the flash block. I'll take a pic of where to connect it. Be back in a bit.

Edit:
Ok, heres a pic. (sorry about the quality, the lock tab is facing upward) I used a lighter and melted the insulation off the wire so I could clip a jumper wire on it with an alligator clip, then ran it to the b+ terminal. I didn't have any problems flashing after that. Some people have said that they had to turn on accessories like the lights or blower motor to avoid a voltage too high error.

* Registered users of the site do not see these ads.

Last edited by cooleys04; 01-13-2010 at 04:36 PM.
cooleys04 is offline   Reply With Quote